peak voltage การใช้

• They require a protective circuit to limit peak voltage.
• An unambiguous and general specification of tolerable transients or peak voltages is not possible.
• To address this, uprated versions with higher peak voltage and power ratings were introduced.
• The peak-to-peak voltage, being double this, is about 340 volts.
• These act as very high speed switches, momentarily limiting the peak voltage across their terminals.
• Electrolytic capacitors with solid electrolyte cannot withstand transients or peak voltages higher than the surge voltage.
• AC transmission lines need to be designed to handle the peak voltage of the AC sine wave.
• The peak voltage to RMS voltage ratio does not maintain the same relationship as for a sine wave.
• The ratio of peak voltage to peak current is due to capacitive reactance ( denoted X C ).
• It is hard to predict the peak voltage in the output, since the input will be distorted.
• The surge voltage indicates the maximum peak voltage value that may be applied during their application for a limited number of cycles.
• Polymer electrolytic capacitors, aluminum as well as tantalum polymer capacitors can not withstand transients or peak voltages higher than surge voltage.
• Normalising for voltage and current, etc . is it because the peak voltage of AC is higher than the average voltage?
• Half-wave rectification and full-wave rectification using a center-tapped secondary produces a peak voltage loss of one diode drop.
• However, each discharge occurred at a different voltage, which was almost always lower than the consistent peak voltage of a synchronous gap.
• The peak voltage of this surge may be as high as 120 V and the surge may take up to 400 ms to decay.
• These organs can generate a peak voltage of about 14 to 37 volts, which they use to stun prey and to defend themselves.
• In the following circuit, a capacitor retains the peak voltage level of the signal, and a switch is used for resetting the detected level.
• However, when a transient peak voltage causes an electric field strength that is too high for the dielectric, it can directly cause a short circuit.
• Integrating the charge pulses from the detector gives a translation of input pulse energy to a peak voltage output, which can then be measured for each pulse.